AT&T Voice Terminal 6434 - Manual (Page 3)

EXIT/NORMAL (display feature)
When you are ready to leave Display or Softkey
Mode and return to Normal (call-handling) Mode
1 Press [ Exit ].
HOLD
To put a call on hold
1 Press [ Hold ].
To answer a new call while active on another
1 Press [ Hold ].
2 Press call appearance button of incoming call.
To return to held call
1 Press call appearance button of held call.
INSPECT (display feature)
To see who is calling while on a call
1 Press [ Inspect ].
● Call source is shown on display.
2 Press [ Exit ] to return to display for present call.
LAST NUMBER DIALED
To automatically redial the last number you
dialed
1 Press [ LastDialed ]
or Dial Last Number Dialed access code .
LEAVE WORD CALLING (LWC)
To leave a message after dialing an extension
1 Press softkey below LWC
or Press [ LWC ] before hanging up your handset.
6
To leave a msssage without ringing an extension
1 While off-hook press softkey below LWC
or Press [ LWC ]
or Dial Leave Word Calling access code .
2 Dial extension.
3 Hang up.
To cancel a Leave Word Calling message
1
2
While off-hook press the softkey below CnLWC
or Press [
Cancel LWC ]
or Dial Leave Word Calling cancel code .
Dial extension.
PRIORITY CALLING
To place a priority call (3-burst ring)
1 While off-hook press the softkey below PCall
or Press [ Priority ]
or Dial Priority Calling access code .
2 Dial extension.
RESET SPEAKERPHONE
To adjust the speakerphone to the surrounding
room acoustics
1 While on-hook, press [
Shift ] and then
press [ Speaker ].
● You hear a series of tones.
SELECT RING (and RINGER VOLUME)
To select a personalized ring
1
2
3
Press [ Shift ] and then press [ Hold ].
● Current ringing pattern plays, and pattern
number is displayed.
To cycle through all eight ring patterns, continue to
press (and then release) [ Hold ] (or press
[ N e x t > ] or [ < P r e v ]).
When you hear the desired ring pattern, press
[ Shift ] again.
7
To adjust ringer volume if necessary (speaker is
not active)
1 To raise the volume, press the right half of the
Volume control button labeled [
∧∧
];
to lower the volume, press the left half of the
Volume control button labeled [
∨∨
]
SEND ALL CALLS
To send all calls (except priority calls) immediately
to coverage
1 Press [ Send Calls ]
or Dial Send All Calls access code .
To cancel Send All Calls
1 While off-hook, press [ Send Calls ] again
or Dial Send All Calls access code .
SPEAKERPHONE
NOTE: To use this feature, your voice terminal must
be set for the Speakerphone (speak and listen)
feature.
To place or answer a call without lifting the
handset, or to use speakerphone with any feature
1 Press [ Speaker ].
2 Place or answer call, or access selected feature.
3 Adjust speakerphone volume if necessary:
To raise the volume, press the right half of the
Volume control button labeled [
∧∧
];
to lower the volume, press the left half of the
Volume control button labeled [
∨∨
].
To prevent the other party from hearing you
1 Press [ Mute ].
● Red Mute light goes on.
2 Press [ Mute ] again to resume talking to party.
● Red Mute light goes off.
8