HP Designjet 4520 Printer series - Manual (Page 42)

4. Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not,
remove the roll, turn it 180 degrees and slide it back on to the spindle.
NOTE: There is also a diagram on the outside face of each paper stop showing the correct
orientation.
5. Press the roll towards the black paper stop until it clicks into place.
NOTE: If you have difficulty with this, try turning the spindle to a vertical position, so that gravity
presses the roll against the stop.
6. Ensure there is no space between the roll and the black stop.
7. Put the blue paper stop on to the other end of the spindle, and push it towards the end of the roll.
32 Chapter 4 How do I... (paper topics) ENWW
Pa
p
er