Unload a roll from the printer [4520 – HP Designjet 4520 Printer series User Manual
Page 46
10.
Wind excess paper back onto the roll. Use the paper stop to turn the roll in the direction shown.
11.
If the printer is unable to detect the paper type, the front panel displays a list of paper types.
Select the paper type you are using. If it is not clear which you should select, see
.
12.
The front panel asks you to specify the length of the roll you are loading. After you have done so,
it will start to load the roll.
NOTE:
Specifying the roll length is not obligatory (you can select Unknown) and has no effect
on the printer's behavior. However, if you give the length, subsequently the printer will keep track
of how much paper is used, and will keep you informed of the remaining length (assuming that the
value you originally gave was accurate).
13.
If the printer's first attempt to load the roll is unsuccessful, it will automatically wind the paper
backwards and try again without requiring any assistance.
If this second attempt is unsuccessful, it will try a third time, but this time the front panel will request
your assistance.
14.
The printer will perform a color calibration, if it has not already calibrated the paper type you are
using, and if color calibration is turned on. See
Perform color calibration on page 68
.
15.
The front panel displays the Ready message and the printer is ready to print.
Unload a roll from the printer [4520]
NOTE:
This topic applies to the HP Designjet 4520 Printer series only.
36
Chapter 4 How do I... (paper topics)
ENWW
Pa
p
er