HP 9000 Virtual Library System - Manual (Page 210)

Status Description Item
Fluttering green = There is hard drive activity, or the array is running a background
parity check of the data in the RAID set.
Off = The hard drive has no power, is offline, or not configured.
Blinking white = Enclosure is selected (for identification purposes only). Unit locator LED 4
Off = Not active. (on for 3–4 seconds at
power up, then off)
Amber = An enclosure-level fault occurred. Service action is required. The event
has been acknowledged but the problem still needs attention. Fault/Service required
LED 5
Off = No fault. (on for 3–4 seconds at
power up, then off)
Green = Enclosure is powered on with at least one power module operating
normally. Power On/OK LED
(on for 3–4 seconds at
power up, blinks for
6
Off = Both power modules are off.
up to 2 seconds
during boot, then on)
Rear Panel Components
Base Enclosure
Description Item
Power module 0 1
RAID controller 0 2
RAID controller 1 3
Fibre Channel port 0 4
Fibre Channel port 1 (not used) 5
Service port (for service only) 6
CLI port (not used) 7
Ethernet port 8
SAS output port 9
Power module 1 10
210 Component Identification