HP XP Array Manager Software - Manual (Page 31)

Figure 9 Specifying HBAs to be Monitored
For more detailed instruction, see “ Setting Priority for Ports on the Storage System ” on page 36.
NOTE:
XP Performance Control is unable to monitor and control the performance of hosts whose HBAs
icons are placed below the
Non-Monitor icon.
3. Set priority to HBAs using the WWN tab of the Performance Control window.
In network B, the production server is given high priority and the development server is given
low-priority. If your network is configured as in
Figure 8 on page 30, you must give high priority
to wwn01 and give low-priority to wwn02 and wwn03.
To give priority to the three HBAs, take the following steps (see
Figure 10 on page 31 below):
a. In the WWN tab, select one of the four ports that the HBAs are connected to (that is, ports
1A, 1C, 2A, and 2C).
b. Set wwn01 to Prio.. Also, set wwn02 and wwn03 to Non-Prio..
Figure 10 Priority specified in the Performance Control Window
4. Monitor traffic between host bus adapter and ports. You must obtain statistics about traffic between
HBA and ports.
If your network is configured as network B, you must do the following:
• Measure traffic between port 1A and the three HBAs (wwn01, wwn02 and wwn03).
• Measure traffic between port 1C and the three HBAs.
XP24000/XP20000 Performance Control User's Guide 31