HP Designjet T1300 ePrinter User Manual
Page 206
Table 20-2
Numerical error codes (continued)
Error code
Recommendation
61:08.1
Resend the job without password protection.
62, 62:04, 63
Update your printer's firmware. See
Update the firmware on page 138
63:01
The printer has failed to get an IP address. Connect to another network or change the IPv4
configuration.
63:04, 64
Update your printer's firmware. See
Update the firmware on page 138
64.1:01
The external hard disk has been removed while it was in use. Please reconnect it and restart
the printer.
64:04, 65, 65:04
Update your printer's firmware. See
Update the firmware on page 138
66:08
The job cannot be printed on the paper type that is loaded.
67, 67:04
Update your printer's firmware. See
Update the firmware on page 138
68:03
Restart the printer.
71.04
Out of memory. To avoid this, in the HP-GL/2 and HP RTL driver select the Advanced tab
and then Send job as a bitmap.
71:03
Restart the printer.
71:04
Update your printer's firmware. See
Update the firmware on page 138
74:04, 74.1:04
The firmware upgrade has failed. Press OK and try again. See
.
74.1
Try the firmware update again. Do not try to use your computer while the update is in
progress.
74.8:04
The firmware upgrade has failed. Your firmware file may be incorrect; try to download it
again. See
Update the firmware on page 138
.
76:03
Restart the printer.
77:04, 78.1:04
Update your printer's firmware. See
Update the firmware on page 138
78:08
Borderless printing not possible; setting ignored..
79:03
Restart the printer.
79:04, 79.1:04
Update your printer's firmware. See
Update the firmware on page 138
81:01
Please follow the instructions on the front panel. You may be asked to run a test procedure and
write down a numeric code before contacting HP Support. See
.
81:03, 84:03
Restart the printer.
86:01
Please follow the instructions on the front panel. You may be asked to run a test procedure and
write down a numeric code before contacting HP Support. See
.
94, 94.1, 94:08
Restart color calibration. See
94:02
Color calibration failed. Check that the paper type that is loaded corresponds to the paper
type that you have selected.
198
Chapter 20 Front-panel error messages
ENWW