HP Designjet T1300 ePrinter - Manual (Page 50)

NOTE: The first three steps below are optional: you can start with step 4. However, in this case the
printer will not keep track of the length of the roll, and will print no barcode on the roll when it is next
unloaded. So you are recommended to follow all the steps, starting with step 1, unless you have turned
off the Printing paper info option. See Printing paper info on page 47 .
1. From the front panel, press , then the roll icon, then Load.
Alternatively, press , then , then Paper > Paper load > Load roll 1 or Load roll 2.
If the roll you have selected is already loaded, you have to wait while it is automatically unloaded.
You should stand behind the printer when loading the lower roll (roll 2). You may stand behind or
in front of the printer when loading the upper roll (roll 1).
CAUTION: If your height is less than 1.6 m (5 ft 3 in), loading a roll while standing in front of
the printer may cause back pain or other physical problems.
2. In the T1300 series only, if you start to load roll 1 while roll 2 is already loaded, roll 2 is
withdrawn to the standby position, so that it can be printed on again without reloading whenever
required.
NOTE: If at any time you open a roll cover while that roll is in the standby position, the roll will
be automatically unloaded, and you will have to reload it the next time you want to print on it.
3. Open the roll cover, if it is not already open.
4. Rest the spindle's black end on the left side roll holder. Do not put the end completely into the roll
holder.
5. Rest the blue end of the spindle on the right side roll holder.
6. With both hands, push the spindle into both roll holders at the same time.
42 Chapter 5 Paper handling ENWW