HP Single Channel Ultra320 SCSI G2 Host Bus Adapter - Manual (Page 12)

Introduction
SCSI Cables
Cables are provided with most HP server products that require cabling. If additional cables
are needed or the correct one was not provided with the server product, they can be ordered
from an authorized HP reseller or authorized HP Service Provider. Refer to Table 1-1 for
cable option kit part numbers.
Table 1-1: External Cable Option Kit Part Numbers
Cable Option Kit Part Number
VHDCI to Wide 6 foot 341176-B21
VHDCI to Wide 12 foot 341177-B21
VHDCI to VHDCI 6 foot 341174-B21
VHDCI to VHDCI 12 foot 341175-B21
Note: An internal 68-pin to 50-pin SCSI adapter (part number 199618-001) is
also available.
If the option kit part number for the cable needed is not listed here, or for additional ordering
information, refer to the HP website at
http://www.hp.com .
SCSI Cable Connectors
To identify the various SCSI cables required in a Single Channel Ultra320 SCSI HBA G2
installation in the various configurations of HP servers, refer to Figure 1-2.
Keep these characteristics of SCSI cables in mind:
•
External VHDCI cables have a round wire with securable connectors, and the connector
heads are smaller than 68-pin external wide SCSI connector heads.
•
Internal SCSI cables have a flat ribbon cable with push-on connectors.
•
HP SCSI cables are keyed so they cannot be installed incorrectly.
HP Single Channel Ultra320 SCSI Host Bus Adapter G2 User Guide 1-5