HP Single Channel Ultra320 SCSI G2 Host Bus Adapter - Manual (Page 14)

2
Installing the Hardware
This chapter discusses the installation of the HP Single Channel Ultra320 SCSI HBA G2 in
an HP server.
WARNING: To reduce the risk of personal injury from electric shock and hazardous
energy levels, only authorized service technicians should attempt to install this
equipment. Consult the safety information and user documentation provided with the
computer before attempting this installation.
Many servers are capable of producing energy levels that are considered hazardous
and are only intended to be serviced by qualified personnel trained in dealing with
these hazards. Do not remove enclosures or attempt to bypass any interlocks that may
be provided for the purpose of removing these hazardous conditions.
Items Needed
•
Torx T-15 screwdriver
•
HP PCI-X U320 HBA Support Software CD or the SmartStart and Support Software CD
•
Documentation that came with the server
Preparing the Server
Use the following general guidelines to prepare the server for installation of the Single
Channel Ultra320 SCSI HBA G2.
WARNING: When working with equipment installed in a rack, be sure that the
equipment and rack are stable before beginning.
To prepare the server:
1. Perform a normal system shutdown.
2. Power down the server.
3. Power down all peripheral devices attached to the server.
4. Unplug the AC power cord from the outlet, and then unplug it from the server.
5. Disconnect all peripheral devices attached to the server.
HP Single Channel Ultra320 SCSI Host Bus Adapter G2 User Guide 2-1