HP StorageWorks IP Storage Router - Manual (Page 105)

Configuring System Parameters
105 IP Storage Router SR2122-2 User Guide
Configuring Passwords
Configuring passwords consists of setting the monitor-mode and
administrator-mode passwords for access to the 10/100 Ethernet management
interface (used for the CLI via Telnet and the web-based GUI via HTTP). You can
enable these passwords to restrict access to the EIA/TIA-232 console interface. To
configure passwords:
Note: The factory default password for both Monitor and Administrator modes is hp.
In a cluster environment, passwords are cluster-wide configuration elements and
apply to all storage routers in a cluster. All password management functions are
handled by a single storage router. If you issue try to set the Administrator or
Monitor mode passwords from a storage router that is not performing password
management functions, the CLI displays an informational message with the name
of the storage router that is currently handling those functions.
To configure passwords
1. enable — Enter Administrator mode.
2. monitor password janu$01 — Set the monitor password (for user
who only monitors storage router operation).
3. admin password elect@50 — Set the administrator password (for
system administrators, allowing configuration changes).
4. restrict console — (Optional) Enable the Monitor-mode and
Administrator-mode passwords to be required when accessing the SR2122-2
via a console connected to the EIA/TIA-232 console interface.
Configuring Administrator Contact Information
Configuring administrator contact information consists of tasks for specifying the
name, e-mail address, phone number, and pager number of the system
administrator for the storage router. To configure administrator contact
information: