HP Ethernet 10Gb 2-port 561T Adapter - Manual (Page 10)

Installing an adapter 10
To install a low profile bracket:
1. With a correctly sized Phillips screwdriver, carefully remove the two board lock screws located at the
top and bottom of the connector.
2. Remove the standard profile bracket, and then place the low profile bracket over the connector.
Be careful not to damage the connector or bind the low profile bracket to the connector.
Connecting the network cable
To secure the cable, plug the cable connector into the RJ-45 port. Ensure that the tab on the plug clicks into
position indicating that it is properly seated.
For more information, see "UTP cable specifications (on page
11 )".