HP Lights-Out 100 Remote Management - Manual (Page 46)

Using LO 100 46
o
Path
is the path of the file relative to the TFTP server root.
o
filename
is the file name of the certificate file (
server_cacert.pem
in this example).
You can also find these commands in /map1/firmware directory.
NOTE: After using the
load
command LO 100 will reset ending your CLP interface session.
You must reconnect to the CLP interface.
To install a private key, log in to LO 100 as administrator through the CLP interface and issue the load
command to upload and install the certificate. For example:
load -source <URI> -oemhpfiletype key
where:
o
<URI>
is the
//tftpserver IP/path/filename
to be downloaded.
o
tftpserver
is the URL or IP address of the TFTP server containing the private key file.
o
Path
is the path of the file relative to the TFTP server root.
o
filename
is the file name of the private key file (
server_privkey.pem
in this example).
You can also find these commands in /map1/firmware directory.
NOTE: After using the
load
command LO 100 will reset ending your CLP interface session.
You must reconnect to the CLP interface.
HP SIM support
HP SIM discovers LO 100 and enables you to identify and launch LO 100. See your HP SIM user guide
for more information on using HP SIM with LO 100.