HP NonStop G-Series - Manual (Page 35)

Installation
HP AutoSYNC User’s Guide—522580-020
2-7
Authorize AutoSYNC
For example:
The following is displayed in the EMS log:
Appendix A, Operations and Management describes further details on configuring and
determining the status of the monitor process.
Authorize AutoSYNC
To perform scheduled synchronizations, the ASYSYNCP process must be granted the
correct access rights. Authorization is the operation that confers these rights by
26> autosync
HP Nonstop(tm) AutoSYNC(tm) Command Interpreter(T2713H01) - System \BLPROD
(C)2010 Hewlett Packard Development Company, L.P.
(C)2010 Carr Scott Software Incorporated
* Error * The monitor process $ZASY is not executing.
* 652 * To start a monitor, issue the START MONITOR command.
AutoSYNC 1? start monitor;
--- Starting Monitor process $ZASY
AutoSYNC Monitor 1.9.1 - 17FEB2012 -- $ZASY (3,765) - System \BLPROD
Started at Jun 29 2012 16:41:39, elapsed time = 0:00:00
Backup process $ZASY (2,1081), no takeovers
Monitor hometerm: $0
EMS event logging level is NORMAL.
AutoSYNC License Information
License is Valid
Maximum logical processors 4
16:47 29JUN12 100,03,176 $ZASY 100 ASYMON starting Version
1.9.1 - 17FEB2012
16:47 29JUN12 100,03,176 $ZASY 149 ASYMON message
AutoSYNC License Information
License is Valid
Maximum logical processors 4
16:47 29JUN12 100,03,176 $ZASY 149 ASYMON message
AutoSYNC Global Settings
AutoSYNC ON
SYNCcompress OFF
SYNCrecover ON
EMSsuppress OFF
SYNCoverIP OFF
SYNCTCPPROCesses $ZTC0,$ZTC1
EMSCollector $0
16:47 29JUN12 100,03,176 $ZASY 101 ASYMON started Version
1.9.1 - 17FEB2012
16:47 29JUN12 100,03,176 $ZASY 104 ASYMON backup started, cpu 2
16:47 29JUN12 100,03,176 $ZASY 112 ASYMON SYNCUSER table cached. Table
entry count = 0.
Note. 1Internally, the default home terminal of the monitor is $ZHOME, as displayed by the
TACL command STATUS $process-name, because an EMS collector cannot be specified as
the home terrminal of a process when the process is started Functionally however, the home
terminal for the monitor process is the default EMS collector, as shown by the Autosync
STATUS MONITOR command.
2.The default EMS collector is $0, or the EMS collector configured by setting the global
parameter EMSCOLLECTOR.