HP 3PAR Host Explorer Software - Manual (Page 20)

4.2 TpdHostAgent Command
HP 3PAR Host Explorer User Guide
-refresh
Stops, then restarts the Host Explorer process.
-status
Lists the status of a Host Explorer process, i.e. whether the daemon/service is
running.
-list
Lists the contents of all host configuration information (Host Explorer tokens) that
has been gathered by the Host Explorer.
-push
Immediately sends the latest Host Explorer token information to the HP 3PAR
StoreServ Storage system.
-set <RefreshInterval>|<PushInterval>
Changes the default time intervals (RefreshInterval = 60 seconds, PushInterval =
86,400 seconds) used by the daemon to send token information to the HP 3PAR
StoreServ Storage system.
◆ RefreshInterval - The interval that the Host Explorer process collects the data and
compares it to the last known state for any changes. If there are changes, the Host
Explorer pushes the new set of data to the HP 3PAR StoreServ Storage system.
◆ PushInterval - The interval that the Host Explorer process pushes data to HP 3PAR
StoreServ Storage system.
-settrace <1-5>
This option is only available on the Windows operating system.
◆ 1 - Displays error messages.
◆ 2 - Display warning messages and all messages below this level.
◆ 3 - Displays information messages and all messages below this level.
◆ 4 - Displays verbose messages and all messages below this level.
◆ 5 - Displays debug messages and all messages below this level.
SPECIFIERS
None.