HP Integrity NonStop J-Series - Manual (Page 163)

NonStop AutoTMF Commands
HP NonStop AutoTMF Software User’s Guide—429952-016
6-87
TRACE
PROGRAM object-file-name | file-set
captures trace information for all instances of the running program or set of
programs.
If this option is used in conjunction with the DEBUG option, the program must
be uniquely specified, not as a pattern.
PROCESS process-name | process-namelist | *
PROCESS cpu-pin
PROCESS cpu,*
captures trace information for the selected set of processes.
If PROCESS is used with the DEBUG option, the process must be uniquely
specified (not as a pattern).
If PROGRAM and PROCESS are omitted, all prepared programs are traced.
option
CLEAR
purges the data in the trace file before writing the first trace entry.
DEBUG [ TERM term-name | MYTERM ]
starts the traced process in INSPECT and sends the INSPECT prompt to one
of the following locations:

to the terminal specified in the TERM option or,

if MYTERM is specified, to the home terminal of the CI session or,

if none is specified, to the home terminal of the process being debugged.
DEBUG can be specified only when tracing a single process; a unique
PROGRAM or PROCESS must be specified.
A process can be debugged only if the TRACE command was entered by
the user id who owns the process, by the group manager, or by the super id.
Specifying DEBUG cannot put a running process in INSPECT.
EDIT
creates the trace file as an Edit file. If this option is specified, only one process
can open the trace file at a time.
EXT 1-to-65535
the extent size of the trace file in 2048 byte blocks. Primary and secondary
extent sizes are the same.
The default is 64.
FOR n