HP Integrity NonStop J-Series - Manual (Page 228)

Error Messages
HP NonStop AutoTMF Software User’s Guide—429952-016
D-8
Critical Event Messages
430
Cause. An authorized user requested a AutoTMF process stop.
Effect. All automatic transactions were committed and the process has been
abended.
Recovery. Informational message only; no corrective action is needed.
433
Cause. The referenced product is licensed for a maximum number of logical NSK
processors (MAXCPUS). The number of active processors exceeds the license
maximum.
Effect. Your license is not valid.
Recovery. Contact the license manager requesting a valid license with sufficient
number of logical processors. Please provide your system serial number and order
number.
437
Cause. The runtime attempted to start tracing but was unable to create a trace file due
to the specified file system error.
Effect. The process continues without tracing.
Recovery. Correct the cause of the file system error. For a dynamic trace, reissue the
TRACE command.
438
Cause. The runtime attempted to start tracing but was unable to open a trace file due
to the specified file system error.
Effect. The process continues without tracing.
Recovery. Correct the cause of the file system error. For a dynamic trace, reissue the
TRACE command.
Process was stopped by user request
System contains more logical processors than permitted by
AutoTMF license.
Error trying to create trace file
Error trying to open trace file