HP ProBook 5220m Notebook PC - Manual (Page 129)

Select To do this
Boot Options ● Set a Startup Menu delay (in seconds).
● Set the MultiBoot Express Boot Popup delay in seconds.
● Enable/disable Custom Logo (disabled by default).
● Enable/disable Display Diagnostic URL (enabled by
default).
● Enable/disable CD-ROM boot (enabled by default).
● Enable/disable SD Card boot (enabled by default).
● Enable/disable floppy boot (enabled by default).
● Enable/disable PXE Internal NIC boot (enabled by
default).
● Enable/disable Unified Extensible Firmware Interface
(UEFI) Boot Mode (disabled by default).
● Set the Express Boot Popup delay in seconds.
● Set the boot order.
Device Configurations ● Enable/disable USB legacy support (enabled by default).
When enabled, USB legacy support allows the
following:
◦ Use of a USB keyboard in Computer Setup even
when a Windows® operating system is not running.
◦ Startup from bootable USB devices, including a hard
drive, diskette drive, or external optical drive
connected by a USB port to the computer.
● Enable/disable fan always on while connected to an AC
outlet (enabled by default).
● Enable/disable Data Execution Prevention. When
enabled, the processor can disable some virus code
execution, which helps to improve computer security.
● Enable/disable LAN Power Save (select models only).
When enabled, saves power by turning off the LAN when
not in use (enabled by default).
● SATA (Serial Advanced Technology Attachment) device
mode. The following options are available:
◦ AHCI (Advanced Host Controller Interface)
◦ IDE (Integrated Drive Electronics)
Computer Setup menus 117