HP Hub & Switch Management for OV-UX - Manual (Page 95)

A-1
Appendix A
Agent Firmware Versions
A
ppen
dix A
A
Appendix A
Appendix A contains the following topics:
■ Agent Firmware Versions
■ Preparing Network Devices
■ Globally Assigned IP Network Addresses
■ Configuring IP Parameters
Agent Firmware Versions
HP Hub & Switch Management communicates with network devices using
SNMP (Simple Network Management Protocol).To access device features,
each network device must contain a compatible version of agent software or
firmware.
Note: The latest firmware agents can be obtained from the Support
section of the HP networking Web page. The URL is:
http://www.hp.com/go/procurve
Verifying Device Agent Versions
You can check the agent version on an HP device using one of the following
methods:
■ Use the device's console port interface (a non-network connection).
You can connect a terminal or computer directly to the device or through
a modem. Refer to the device's Installation and Reference Guide for use
of the device's RS-232 console port.
• For HP devices, you can use an ASCII terminal or computer with
VT 100 terminal emulation.
■ Use an available network application (a network connection).