HP ProLiant BL465c G7 Server-Blade - Manual (Page 25)

Hardware options installation 25
6. Install the DIMM.
7. Install the DIMM baffle.
8. Connect the hard drive cables (" Hot-plug SAS/SATA hard drive cabling " on page 39 ).
9. Connect the cache module capacitor cable (" Cache module capacitor cabling " on page 39 ).
10. Install the access panel (on page 15 ).
11. Install the server blade (" Installing a server blade " on page 18 ).
Hot-plug SAS or SATA hard drive option
IMPORTANT: To avoid improper operation, install only hot-plug hard drives in this server
blade.
IMPORTANT: The following configurations are not supported:
• Installation of both SAS and SATA hard drives in a single RAID volume
• Installation of SSD and rotating media hard drives in a single RAID volume
A Smart Array P410i controller with an embedded FBWC module supports either two hot-plug SAS or two
hot-plug SATA hard drives. Hard drive activity is indicated by the hard drive LEDs on the hard drives.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.