HP McDATA 4Gb SAN Switch for HP BladeSystem p-Class - Manual (Page 33)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem user guide 33
• View properties for the selected security set, group, or group member.
Create Security Set dialog
Use the Create Security Set dialog shown in Figure 15 to create a new security set. There is a maximum of
4 security sets.
Figure 15 Create Security Set dialog
To add a security set from the faceplate display, perform the following procedure:
1. Click Security on the tool bar, or select Security > Edit Security to open the Edit Security dialog.
2. To open the Create a Security Set dialog, choose one of the following:
• Click Security Set in the Edit Security dialog tool bar.
• Right-click in the graphic window of the Edit Security dialog, and select New Security Set from the
popup menu.
3. Enter a name for the new security set. The naming conventions for security sets are:
• Must start with a letter.
• All alphanumeric chars [aA—zZ] [0—9].
• The symbols $_ - and ^ are the only symbols allowed.
4. Click OK to save the change.
Create Security Group dialog
Use the Create Security Group dialog, shown in Figure 16 , to add a security group to a security set. To
open the Create a Security Group dialog, choose one of the following:
• Click Security Group in the Edit Security dialog tool bar.
• Right-click in the graphic window of the Edit Security dialog, and select Create a Security Group
from the popup menu.
Figure 16 Create Security Group dialog
The naming conventions for all security groups are listed below.
• Must start with a letter.
• All alphanumeric chars [aA—zZ] [0—9].
• The symbols $_ - and ^ are the only symbols allowed.
An empty (no members) security group in the active security set will prevent all connections for that security
group type. For example, an empty ISL security group will cause the switch to refuse all logins from other
switches. To add a security group to a security set, perform the following procedure:
1. Click Security on the tool bar in the faceplate display or select Security > Edit Security to open the Edit
Security dialog.