Supported configurations using hp cwdm mux modules, Figure 1, Figure 2 – HP Coarse Wave Division Multiplexer User Manual

Page 12: Figure 3

Advertising
background image

•

One monitor port, also known as tap port, optionally used to connect optical monitoring

equipment for checking optical link quality

•

One network port to allow users to connect to additional CWDM modules to extend their SAN

or network

•

Dual LC-type connectors for all optical connections

Figure 1 HP StorageWorks CWDM 8-port Multiplexer/Demultiplexer module

HP CWDM Slot A 4-port and HP CWDM Slot B 4-port Add/Drop MUX modules

The CWDM Slot A 4-port Add/Drop Multiplexer (

Figure 2

) and CWDM Slot B 4-port Add/Drop

Multiplexer (

Figure 3

) modules are passive optical devices and do not require power. The two modules

have the following features:

•

Add/drop capability for four CWDM wavelengths

•

Identical functionality with different sets of four wavelengths

•

Allow wavelengths that have not been dropped to continue transmitting on the network without

interference

•

Four unidirectional fiber pairs for equipment side drops

•

Two monitor ports, also known as tap ports, optionally used to connect optical monitoring equipment

for checking optical link quality

•

One network port and one pass port enabling users to optionally connect to additional CWDM

modules to extend the SAN or network.

•

Dual LC-type connectors for all optical connections

Figure 2 HP StorageWorks CWDM Slot A 4-port Add/Drop Multiplexer

Figure 3 HP StorageWorks CWDM Slot B 4-port Add/Drop Multiplexer

Supported configurations using HP CWDM MUX modules

The HP CWDM MUX modules enable users to expand the capacity of point-to-point networks that

typically utilize a single pair of single mode optical fiber. This is useful in situations where there is either a

limited supply of, or access to, optical fiber. In these situations, a point-to-point optical network is typically

used to carry data between two end points without branching out to other points or nodes. Point-to-point

connections can be expanded four or eight-fold when the CWDM 8-port Multiplexer/Demultiplexer

module is deployed at each end. This type of connection is usually the best way to transport many

12

About HP CWDM MUX modules and CWDM (SFP) transceivers

Advertising