HP StorageWorks 1500cs Modular Smart Array - Manual (Page 43)

Scripting in ACU 43
Message Comment or explanation (if not self-explanatory)
New array ID already exists. This error occurs in Configure mode when the array ID in the script
file already exists in the configuration. You can only use Configure
mode to create new arrays.
New array ID does not match the
next available array ID. The array ID that you specified in the script file does not match the
ID of the newly created array. For example, the script generates this
error if you have only an array A and the script file specifies
creation of array C (missing array B).
New logical drive ID already
exists. This error occurs in Configure mode when the logical drive ID in the
script file already exists in the configuration. You can only use
Configure mode to create new logical drives.
New logical drive ID does not
match the next available logical
drive ID. The logical drive ID that you specified in the script file does not
match the ID of the newly created logical drive. For example, the
script generates this error if you have only logical drive 1 and the
script file specifies creation of logical drive 3 (missing logical drive
2). This error can occur when using an input file with logical drive
numbers that are not sequential. In this case, change the logical
drive numbers so that they are sequential in the input file.
No controllers detected. This error applies to input mode only. If no controllers are detected
in capture mode, the capture file is empty.
Slot information is not available. You cannot run Input mode on internal controllers that do not have
slot information online. For Microsoft®
Windows®, you must load
the System Management Driver.
Too many coinciding expansion,
migration, or extension operations. ACU does not support multiple simultaneous expansions, migrations,
or extensions without saving the configuration between operations.
Limit the number of such configuration changes in this script.
(text) is not an HBA command. A command found in the HBA section is not a valid command for
this section.