HP Designjet 9000s Printer series - Manual (Page 185)

No. Item Item display
(upper line) Parameters
display (lower
line) Description Initial value
2 Heat suspending
time after printing DELAY TIME 00 to 30 MINUTES UNIT: minute 05 MINUTES
3 Standby heating
time after
completion of
DELAY TIME STANDBY TIME 0, 30, 60, 90,
120, ENDLESS Unit: minutes 30
4 Version display VERSION FW=vv.r HW=vv.r Display only –
5 Diagnostics DIAGNOSTICS NO, YES NO: Does not
perform the
diagnostics.
YES: Performs
the diagnostics.
NO
6 Display language LANGUAGE ENGLISH
JAPANESE
– ENGLISH
7 Exit setup mode EXIT YES, NO YES: Exits the
parameter setup
mode.
NO: Does not exit
the parameter
setup mode.
YES
*1 Display only, ON/OFF key is ignored.
Heater error messages
When the following error messages are displayed on the heater front panel, contact HP Support.
● System error
● The relay board cannot be detected
● Front heater thermistor temperature error (-10 °C or less, 70 °C or more)
ENWW Heater error messages 175
Tell me about
t
h
e heat
ers