HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem User Manual
Page 33
Domain management 33
However, the Administrator password can be changed. The default Administrator password is identified
on the Default Network Settings label on the VC-Enet module in bay 1 of the enclosure. To reset the
Administrator password to the factory default, see the information on resetting the administrator password
and DNS settings in the HP Virtual Connect for c-Class BladeSystem Setup and Installation Guide.
The following tasks can be performed on this screen:
•
To create a new local user account, click Add User. The User Settings screen is displayed.
•
To edit attributes of a defined local account, select the user name from this screen.
•
To delete a user account, click the Delete icon for that line item, and then click Apply.
•
To enable strong passwords or enable local users, click Advanced.
To enable the use of strong passwords, select the Require Strong Passwords checkbox. Use the up and
down arrows to select a password length between 3 and 40 characters. With strong passwords enabled,
passwords must also contain at least one character from three of the following four categories:
•
Upper-case character
•
Lower-case character
•
Numeric character
•
Non-alphanumeric character
To enable local users, select the Enable Local Users checkbox. To disable local users, deselect the Enable
Local Users checkbox. If you disable local users before properly setting up both directory services groups
and directory services, you cannot log in to the Virtual Connect Manager.
The following table describes the columns within the Domain Settings (Local Users) screen.