HP NonStop G-Series - Manual (Page 58)

Switchovers
ServerNet Nomadic Disk User’s Guide— 425485-001
5 -4
Moving the Fiber Optic Switches to the Opposite
Position
Moving the Fiber Optic Switches to the Opposite
Position
A switch card determines the position of the fiber-optic switch: straight or crossed. To
move the fiber-optic switches to another position, do one of the following:
•
If you are using Nomadic Disk Manager, the GIVE command performs the
switching.
•
If you are not using Nomadic Disk Manager:
•
Issue commands from the Switch Command Interface (SWCI) to each switch.
See
Section 6, Switch Command Interface (SWCI) . The SWCI commands affect
the switch card only if the key switch on the switch controller card is set to the
REMOTE position.
•
Physically move the toggle switches. The toggle switches affect the switch card
only if the key switch on the switch controller card is set to the LOCAL
position.
Example 5-2. NDCONFIG on \BCK
SET PATH P $ MOD1.#A 1 CROSSED
SET PATH B $ MOD1.#A 2 CROSSED
SET PATH M $TRM1.#A 1 STRAIGHT
SET PATH MB $ TRM1.#A 2 STRAIGHT
SET VOL $DATA01
SET VOL $DATA02
SET VOL $DATA03
SET VOL $DATA04
SET VOL $DATA05
SET VOL $DATA06
SET VOL $DATA07
SET VOL $DATA08
ADD SEGMENT SEGMENT-1, DATA