HP NonStop G-Series - Manual (Page 89)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk User’s Guide—425485-001
6- 25
UNLOCK Command
UNLOCK Command
The UNLOCK command instructs the specified switch card to change to the unlocked
state.
n
Is an integer in the range of 1 through 8 that identifies the slot number of the switch
card to be unlocked.
Considerations
•
The key switch on the SCC must be in the REMOTE position for this command to
succeed.
•
You must specify a valid slot number. If no slot number is specified, or if the
specified slot does not contain a switch card, SWCI returns an error message.
•
If the UNLOCK command is successful, SWCI returns a message stating that the
specified switch card is now unlocked. If the command is unsuccessful, SWCI
returns an error message.
Example
To unlock the switch card in slot 3:
SWCI $NDSWA.#TERM> UNLOCK SC 3
Switch card 3 is now unlocked
UNLOCK SC n