HP VMA-series Memory Arrays - Manual (Page 152)

152 HP VMA SAN Gateway User’s Guide AM456-9026A
Display current terminal width and length, whether auto-detected or overridden, as well as the
current terminal type. This is a subset of the information displayed by show cli , and is only
present for Cisco compatibility.
General Configuration Commands
This section describes CLI commands for these tasks:
• View Installed Licenses on page 152
• Event Logging Configuration and Viewing on page 152
• User Accounts and Local Authentication on page 158
• NTP, Clock, and Time Zones on page 160
• Event Notification on page 162
• Diagnostic Tools on page 167
• Statistics on page 169
• Configuration File Management on page 172
• Image Management on page 176
• Enable and Configure Modes on page 176
• Web Proxy Settings on page 177
• Xinetd Server Settings on page 178
• tcpdump Capture Files on page 178
• Debug Dumps on page 179
• Cluster Configuration and Show Commands on page 180
View Installed Licenses
show license
Displays licenses installed on the system, along with associated license key.
Note: If an installed license shows No as its Active output, an error may have been made when
inputting the license key. Double-check the valid license key against the key that is shown in the
show license output.
Event Logging Configuration and Viewing
This section provides the syntax for event log commands, along with an explanation of the
functionality of each command.