HP Designjet 3D Printer series - Manual (Page 19)

15
Setup
Figure 7 Rewinding the material spool
8. Using a cutters, cut the excess 2 inches (50mm) of material from the material guide. leaving
a blunt end.
9. Power the printer off at the power switch.
10. When the display is blank and the printer has shut down, turn the circuit breaker to the OFF
position.
11. Disconnect the power cable, network cable and material bay cable.
12. Disconnect the model and support material tubes from the printer and the material bay by
pressing in on the coupler ring and pulling the tubes outward.
13. With 2 people, use the handgrips to lift the printer off of the material bay and place on a
flat stable surface. See Figure 8.
Figure 8 Separating the printer and material bay
14. Position the second material bay on top of the existing material bay. Be sure the feet and
pins are properly aligned. See Figure 9.
Figure 9 Positioning material bays
15. With 2 people, position the printer on to the top of the material bays. Be sure the feet and
pins are properly aligned. See Figure 10.