HP Designjet 3D Printer series - Manual (Page 37)

33
Oper
at
ion
3. Press Load Upgrade. The printer will then display “Send upgrade from workstation”
followed by the printer’s IP address.
4. Open HP Designjet 3D Software Solution and click on the Printer Services tab.
5. Click on the Update Software button. HP Designjet 3D Software Solution will now connect
to the printer and will prompt you to locate the upgrade file. Navigate HP Designjet 3D
Software Solution to the directory where the upgrade file is located. The update will
automatically be loaded on to the printer. After the update has been loaded, the display
will show Verifying update.
6. When verification is complete, the display will show Reboot to complete. Press Yes. The
printer will now reboot and return to Idle.
7. Press the Maintenance button and verify the updated version was installed correctly then
exit maintenance.