Save system config, Set drive hostport mode, Save system config set drive hostport mode – HP Command View for Tape Libraries Software User Manual
Page 204
Examples
To generate a support ticket for the Interface Manager card:
/>save mgmt lttsupportticket
Generating support ticket done
You can get your support ticket by using anonymous FTP.
See also
save interface lttsupportticket
save system config
Description
Saves the system configuration so that it can be restored at a later time using
the restore system config command. The system configuration includes
the Interface Manager card, interfaces, and licensed features configuration.
This command overwrites any previously saved system configuration. After
entering this command, you are prompted to input whether you are sure you
want save the system configuration.
CAUTION:
In I240 and above you can restore the configuration for two
major revisions back. For example I270 can restore configurations saved with
I260 and I250. Saving and restoring the configuration must be done with the
same version of the Interface Manager firmware for I232 and below. For
example, you cannot save the configuration with Interface Manager firmware
version I230, upgrade to version I231, and then restore the configuration.
NOTE:
This command saves the configuration to the
IM_save_snapshot.zip
file in the FTP directory.
Syntax
save system config
[force]
Availability
All users and modes
Operands
Specify force to skip the prompt asking if you are sure you want
to save the current system configuration. This operand is optional.
[force]
Examples
To save the system configuration:
/>save system config
Caution: Saving the system configuration will overwrite the last
saved system configuration.
Do you really want to save the system configuration (y/n)? y
Saving the system configuration...done
To save the system configuration, skipping the prompt:
/>save system config force
Saving the system configuration...done
See also
NOTE:
Back up the system after any change to the physical configuration of the library. A
successful restore will not occur if the configuration file contains references to a physical configuration
that no longer exists.
set drive hostport mode
Description
Sets the mode for all host ports for the drive entered or all LTO4 and later
drives.
Syntax
set drive hostport mode
[drive_num] | [all]
mode
[alpa]
Availability
All users and manual mode only
204 CLI Command Reference