HP 3PAR Recovery Manager Software for Microsoft SQL Server Licenses - Manual (Page 62)

RMSql timeconfig
SYNTAX
RMSql timeconfig [-s <WindowsHost>] [-prt <promotetime>][-bkt
<backuptime>] [-ai <analyzeinterval>]
DESCRIPTION
After you install Recovery Manager for SQL, by default the wait time for snap volume restore is
30 seconds, the wait time for backup is 5 minutes, and the wait time for analysis of the repository
with the HP 3PAR Storage System is 60 minutes. You can use this command to change these values.
PARAMETERS
-prt <promotetime> Optional. The time in seconds to wait for volume promotion. If not
specified, 30 seconds is used as the default wait time.
-bkt <backuptime> Optional. The time in minutes to wait for backup. If not specified,
5 minutes is used as the default wait time.
-a <WindowsHost> Optional. The Windows host on which Recovery Manager is
installed. If not specified, the local host is used as the default.
-ai <analyzeinterval> Optional. The time in minutes to wait for automatically analysis of
the repository against the system. Valid values are 10-1440 (10
minutes to 24 hours). If not specified, 60 minutes is used as the
default.
NOTE: If you use the -ai command to modify the analyze interval, you must restart Recovery
Manager for SQL for the change to take effect.
EXAMPLES
The following command queries the time value for each setting.
RMSql timeconfig
The following command changes the promote time to 50 seconds.
RMSql timeconfig -prt 50
The following command changes the backup time to 7 minutes.
RMSql timeconfig -bkt 7
The following command will change the analyze interval to 30 minutes
RMSql timeconfig -ai 30
NOTE: In most cases, there is no need to change these values unless the backup and/or volume
restore are taking an unusually long time to complete.
62 Using the Recovery Manager CLI