HP Designjet T1120 Printer series - Manual (Page 62)

Turn the automatic cutter on and off
To turn the printer's paper cutter on or off:
● From the HP Printer Utility for Windows, select the Settings tab and change the Cutter option
in Printer Settings > Advanced.
● From the HP Printer Utility for Mac OS, select Configuration > Printer Settings > Configure
Printer Settings and change the Cutter option.
● From the Embedded Web Server, select the Setup tab, then Printer Settings > Advanced, and
change the Cutter option.
●
Press the Menu key to return to the main menu, select the Setup menu icon , then Print
retrieval > Enable cutter and change the cutter option.
NOTE: To cut rolled paper while the automatic cutter is disabled, see Feed and cut the paper
on page 53 .
Feed and cut the paper
To feed and cut the paper when the automatic cutter has been disabled, press the Form feed and cut
key on the front panel. The paper advances and the printer makes a straight cut on the front edge.
TIP: If the printer is waiting to nest more pages, you can cancel the waiting time and print the available
pages immediately by pressing the Form feed and cut key .
NOTE: The printer may not cut the paper directly after pressing the Form feed and cut key , as
each time a print is printed the printheads are serviced and the paper cannot be cut until the process
completes.
Remove the cut piece from the output tray.
CAUTION: If strips or short prints are left in the output tray the printer could jam.
NOTE: Photo and coated paper requires careful handling, see The print is scuffed or scratched
on page 158 .
ENWW Turn the automatic cutter on and off 53
P
ape
r ha
n
d
lin
g