HP Hitachi Dynamic Link Manager Software - Manual (Page 108)

Format
To Set the Host Operating Environment
dlnkmgr [-s host-name -u user-name -p password] set
{-lb on -lbtype {exrr|exlio|exlbk|vmwmru|vmwrr}
|-iem {on [-intvl error-monitoring-interval] [-iemnum number-
of-times-error-is-to-occur]|off}
|-expathusetimes number-of-path-use-times
|-dpc {on|off} [-pathid path-ID -lu|-pathid path-ID -storage]
|-dpcintvl checking-interval
}
[-s]
To Set the Remote Management Client Operating Environment
dlnkmgr -l set
{-lic
|-audlog {on [-audlv audit-log-data-collection-level] [-
category [[ss] [a] [ca] [all]]|off}
}
[-s]
To Display the Format of the Set Operation
To display the format of the operation for both a host and remote
management client:
dlnkmgr set
-help
To display the format of the operation for a host:
dlnkmgr -s host-name -u user-name -p password set
-help
To display the format of the operation for a remote management client:
dlnkmgr -l set
-help
Parameters
To Set the Host Operating Environment
The table below shows the defaults and recommended values for each
setting. If you change the value of the set operation, the new value takes
effect immediately.
6-16
Command Reference
Hitachi Dynamic Link Manager User Guide for VMware ®