HP Scanjet Enterprise 8500 fn1 Document Capture-Workstation - Manual (Page 29)

Table 3-6 Jetdirect menus (continued)
Menu item Sub-menu item Sub-menu item Values and Description
Refresh Yes
No
Link Speed The link speed and communication mode of the
Jetdirect server must match the network. The available
settings depend on the product and installed Jetdirect
server. Select one of the following link configuration
settings:
CAUTION: If you change the link setting, network
communications with the Jetdirect server and network
product might be lost.
Auto (default): The Jetdirect server uses auto-
negotiation to configure itself with the highest link
speed and communication mode allowed. If auto-
negotiation fails, either the
100TX Half value or the
10T Half value is set depending on the detected link
speed of the hub/switch port. (A 1000T half-duplex
selection is not supported.)
10T Half : 10 Mbps, half-duplex operation.
10T Full : 10 Mbps, full-duplex operation.
100TX Half : 100 Mbps, half-duplex operation.
100TX Full : 100 Mbps, full-duplex operation.
100TX Auto : Limits auto-negotiation to a maximum link
speed of 100 Mbps.
1000T Full : 1000 Mbps, full-duplex operation.
Configure language settings
To configure language settings, follow these steps:
1. At the product control panel, touch the Administration button, touch the Display Settings menu, and
then touch the Language Settings option.
2. Under Language , touch the language for the control panel display.
3. Under Keyboard Layout , touch the keyboard layout for the touch screen keyboard, and then touch
Save .
NOTE: The language you select can impact the organization of the keys on the touch screen
keyboard. Also note that there may be more than one keyboard layout for a specific language.
NOTE: You can also configure language settings by touching the Language button on the Home
screen.
Basic configuration using the Administration menu 21