HP CD-Writer Plus Internal 8200i Drive - Manual (Page 6)

English-6 Installing CD-Writer Plus and Software
5. When the CD-Writer Plus Install Recommendation screen appears, click
Print. Or, if you don’t have a printer, copy the information by hand.
You’ll need this information in the next section.
6. If you are replacing the CD-ROM drive, remove Software Disc 1 from
your CD-ROM drive.
7. After getting the Install Recommendation, you must shut down your
computer when prompted, and turn off your computer, monitor, and
connected devices. Unplug the power cords from power outlets.
8. Remove the cover from your computer.
9. Prepare the drive bay:
If you are installing the drive into an empty drive bay, remove the
cover plate from a larger half-height drive bay (approx. 6” x 1.75”/15cm x
4.5 cm)
.
If you are replacing an existing CD-ROM drive, remove the drive. Take
note of where the cables are attached and lay them aside to reconnect to
the CD-Writer Plus. You will not need the data cable that came with your
CD-Writer Plus. If an audio cable was connected to the drive you just
removed, you can attach it to your CD-Writer Plus.
10. If the bay requires special rails or brackets to mount the CD-Writer, locate
an extra set or contact your computer manufacturer to purchase
necessary hardware.
11. Write the CD-Writer Plus’ serial number in the space below. The serial
number is on the main label on the top of the drive.
12. Read the Install Recommendation you printed earlier to learn if the
jumper on the CD-Writer Plus should be set as Master or Slave.
13. Find the pairs of pins labeled Master, Slave, and Cable Select on the back
of the CD-Writer Plus. Notice that one pair of pins has a small plastic cap
or jumper. This jumper can be pulled off using your fingers, tweezers, or
needlenose pliers, and placed on a different pair of pins to change the
setting.
Serial
number: