Link speed setting – HP LaserJet P2055dn User Manual

Page 53

Advertising
background image

Link speed setting

NOTE:

Incorrect changes to the link speed setting might prevent the product from communicating with

other network devices. For most situations, the product should be left in automatic mode. Changes can
cause the product to power cycle. Changes should be made only while the product is idle.

1.

On the control panel, press

OK

.

2.

Use the arrow buttons to select Network config., and then press

OK

.

3.

Use the arrow buttons to select CFG LINK, and then press

OK

.

4.

Use the arrow buttons to select LINK, and then press

OK

.

5.

Use the arrow buttons to select one of the following settings.

AUTO

10T HALF

10T FULL

100TX HALF

100TX FULL

100TX AUTO

1000TX FULL

NOTE:

The setting must match with the network product to which you are connecting (a network

hub, switch, gateway, router, or computer).

ENWW

Network configuration

41

Advertising
This manual is related to the following products: