HP LaserJet P2055dn - Manual (Page 117)

Control-panel message Description Recommended action
Memory is low
Press [OK]
The product memory is almost full. Press OK to finish the job, or press the Cancel
button to cancel the job.
For information about increasing the product
memory, see
Install memory on page 85 .
Misprint
Press [OK]
Print media has been delayed as it moves
through the product. Press OK to clear the message.
Non-HP supply installed A non-HP supply is installed. If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit .
Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.
Order black cartridge
Ready
The print cartridge is nearing the end of its
useful life. Order a new print cartridge. You can continue
printing with the current print cartridge until
redistributing the toner no longer yields
acceptable print quality.
See Supplies and accessories on page 131
for more information.
Output bin full
Remove all paper from bin
The output bin is full. Remove all paper from the bin.
Rear door open The product rear door is open. Close the door.
Remove shipping lock from black
cartridge A print cartridge shipping lock is installed. Be sure that the print cartridge shipping lock
has been removed.
Used cartridge in use A refilled print cartridge was detected and
accepted. No action necessary.
Used cartridge installed
To accept press [OK]
A refilled print cartridge is installed. Press OK to continue.
ENWW Interpret control-panel messages 105