HP LaserJet P2055dn - Manual (Page 29)

Menu item Description
WEB Embedded Web server accepts communications using HTTPS (Secure HTTP) only, or both HTTP
and HTTPS.
● HTTPS: Accept only HTTPS (print server appears as a secure site).
● HTTP/HTTPS: Accept either HTTP or HTTPS.
SECURITY Reset current security settings to factory defaults.
● KEEP (default): Retain current security settings.
● RESET: Reset security settings to factory defaults.
FIREWALL Disable Firewall.
● KEEP (default): Retain Firewall operation as configured.
● DISABLE: Disable Firewall operation.
PRINT Print a configuration page for the selected item.
SECURITY: Print the current security settings.
CFG LINK Manually configure the HP Jetdirect print server's network link.
Set the link speed and communication mode. These must match the network. The available
settings depend on the print server model.
CAUTION: Changing the link setting can cause the loss of network communication with the print
server.
● AUTO (default): Use auto-negotiation to set the highest link speed and communication mode
allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the
detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.)
● 10T HALF: 10 Mbps, half-duplex operation.
● 10T FULL: 10 Mbps, Full-duplex operation.
● 100TX HALF: 100 Mbps, half-duplex operation.
● 100TX FULL: 100 Mbps, full-duplex operation.
● 100TX AUTO: Limits auto-negotiation to a maximum link speed of 100 Mbps.
● 1000TX FULL: 1000 Mbps, full-duplex operation.
ENWW Network config. menu 17