HP Insight Management-Software - Manual (Page 57)

set iscsi-boot-param
The -set iscsi-boot-param command configures the basic iSCSI boot parameters on the
specified iSCSI connection.
Syntax
-set iscsi-boot-param
–profilename <profileName>
-portnumber <PortNumber>
-bootorder <Primary|Secondary|Disabled|USEBIOS>
[-lun <Logical Unit number>]
[-initiatorname <Initiator name>]
[-initiatorip <IP address>]
[-mask <Netmask>]
[-gateway <Gateway>]
[-vlanid <Vlan Id>]
[-targetname <Target Name>]
[-targetip <Primary Target IP>]
[-targetport <Primary Target Port>]
[-targetip2 <Alternate Target IP>]
[-targetport2 <Alternate Target Port>]
[-authentication <None|CHAP|CHAPM>]
[-username <username>]
[-secret <secret password>]
[-mutualusername <username>]
[-mutualsecret <Mutual secret password>]
[-iscsibootparamdhcp <enabled|disabled>]
[-networkparamdhcp <enabled|disabled>]
[-dhcpvendorid <VendorID>]
Parameters
Table 22 Parameter descriptions for -set iscsi-boot-param
Optional Required Description Parameter
x Specifies the name of the
profile associated with the
iSCSI boot parameters. -profilename
x Specifies the number of the
port for this set of
parameters. -portnumber
x Enables or disables iSCSI
boot. Selecting primary, -bootorder
secondary , or usebios
enable iSCSI boot. The
default selection for this
attribute is disabled.
x Specifies the LUN of the
target, which identifies the -lun
volume to be accessed.
Valid values for standard
LUNs are 0 to 255 decimal.
Valid values for extended
LUNs are 13- to
16-character hexadecimal
values. The default value is
zero.
set iscsi-boot-param 57