HP Netserver L Server series - Manual (Page 23)

Chapter 3 Installing UPS Software
17
3. At the Command Line prompt, type the following:
{drive}:\PWA\NETWARE\DISK1\SETUP.EXE
where {drive} is the letter of the CD-ROM drive.
4. Follow the instructions on the screen.
◊ You will be prompted to identify an installation path for the software.
◊ In the Installation Options window, select PowerWise Assistant.
◊ You will need to identify the server as a Master or a Slave. For the
Master server, you must identify the port on the server to which the HP
PowerWise UPS is connected. For a Slave server, you must provide
the name of the Master.
5. Depending on your installation choices, one or more of the following
commands are added to the AUTOEXEC.NCF file:
load aiocomx
load hpups
load hpslave
load hpupscag
load hpupssd
Either reboot the server to load these files, or manually load them by
entering pwaload at the server console.