Figure 47 set ssid window, 47 set ssid window, Figure 47 – HP StorageWorks XP Remote Web Console Software User Manual
Page 80: Step 10
80
Configuring external LUs
list, and select Detail. To cancel settings, right-click the setting in the Preset list, and select Delete.
.
10.
If you need to set an SSID to the mapped internal LDEV, the SSID pane appears. When storage is
partitioned using XP Disk/Cache Partition, select the SLPR number in the SLPR box. If you select the
Limited check box and select the SLPR number, you can set only SSIDs that can be used for the selected
the SLPR. If you do not select the Limited check box, you can set the SSID from all unused SSIDs
regardless of the selected SLPR number. Right-click the CU:LDEV number on the SSID pane, and select
Set SSID. The Set SSID window appears.
Figure 47
Set SSID window
11.
Enter the SSID. If you selected the Limited check box on the SSID window, only SSIDs that can be used
in the SLPR selected on the SSID pane appear in the drop-down list. If you did not select the Limited
check box on the SSID pane, all unused SSIDs appear in the list, regardless of the selected SLPR. You
can enter 0x0004 to 0xFFFE as an SSID.
12.
Click OK. The Set SSID window closes, and the LU Operation pane appears.
Settings appear in blue italics in the Device tree and Device list and also appear in the Preset list. To
check setting details, right-click the setting in the Preset list, and select Detail. To cancel settings,
right-click the setting in the Preset list, and select Delete.
13.
Click Apply. A confirmation message appears.
If you already stopped the application, go to
. If you have not stopped the application, click
Cancel to close the message pane, stop the application, and retry the operation.
14.
Click OK. A confirmation message appears.
15.
Click OK. The mapping set in the Add LU window is applied to the local array, and the specified
contents appear in the Device list.
If errors occur during the external LU mapping operation, failed settings and error codes appear in the
Preset list. To check error messages, right-click the failed setting, and select Detail.
Mapping multiple external LUs at one time (Add LU (Auto))
This section describes the procedure to map multiple external LUs at one time. The procedure starts with the
Add LU (AUTO) command.
NOTE:
Before mapping the external LU, you must check whether any application (for example, RAID
Manager XP) using the command device is in progress. If any application using the command device is in
progress, stop the application.
When mapping multiple external LUs at one time, the CU:LDEV numbers for the mapped destination
internal LDEVs are assigned in a series. When performing the mapping operation, you can select the first
CU:LDEV number for the mapped destination internal LDEVs. External Storage XP assigns the selected
CU:LDEV number as the first mapped destination LDEV, and as many subsequent CU:LDEV numbers are
kept for mapping as the number external LUs required to be mapped. To automatically perform the
mapping operation, you can let External Storage XP select the first CU:LDEV number.
NOTE:
If you set Interval for the mapping, the CU:LDEV number of the internal LDEV that must be
mapped is set to the specified interval value.