HP Deskjet 450 Mobile Printer series - Manual (Page 64)

7-16 ENWW
Solving media feed problems
This section provides solutions to common media feed problems.
Media is not picked up from the input tray
Make sure to pull up the input tray extension.
Remove the media, fan it, and reload.
Make sure the media is squarely against the alignment guide and that the
paper guide is snug, but not tight, against the media. For media using the
card slot, make sure the media is aligned squarely against the right edge of
the card slot. Adjust the paper guide on the slot until it fits snugly against
the left edge of the media.
Make sure the media you are using is not wrinkled, bent or curled. Uncurl
paper by bending it in the opposite direction of the curl. Do not leave media
in the input tray overnight. Leaving media in the input tray overnight can
cause it to bend.
Do not load more than 45 sheets of plain paper or a stack paper more than
0.18 in (4.5 mm) thick into the input tray. For other media input capacity,
see
Printer Specifications .
Paper skew
Make sure to fully extend the input tray extension.
Remove the media, fan, and reload.
Make sure the media is squarely against the alignment guide and that the
paper guide is snug, but not tight, against the media. For cards, make sure
they are aligned squarely against the right edge of the card slot. Adjust the
paper guide on the slot until it fits snugly against the left edge of the media.
Make sure the media you are using is not wrinkled, bent or curled. Uncurl
paper by bending it in the opposite direction of the curl. Do not leave media
in the input tray overnight. This can cause it to bend.
Paper output problem
Remove excess media from the output area. If printed media stacks up
outside the output slot, it may prevent media from properly exiting the
printer.