HP Designjet 10000s Printer series - Manual (Page 19)

5 How to use the dryer
Basic operating procedure
1. Press the Power button (2) to switch on the dryer (the operation panel and air flow lamp come on).
2. Press the Heater button (4) to set the operation mode (the Fan lamp (7) and the Heater lamp (8)
will come on).
● If the Fan button (3) has been pressed before the Heater button (4), you will not be able to
turn on the heater by pressing the Heater button (4). You must press the Fan button (3) again
(so the Fan lamp (7) goes off) and then press the Heater button (4) so that hot air operation
starts (both the Fan lamp (7) and the Heater lamp (8) should come on).
● Warm air operation can be restarted by pressing the Heater button (4) while the fan is turning
for three minutes after the heater has been switched off.
3. The timer is used to set the operation time of the dryer. It can be set to a time of up to 24 hours.
● The default setting of the timer is 10 hours.
● You cannot change the time on the timer during the three minute cooling-off period.
NOTE When the remaining time on the timer reaches 0, warm air from the fan will stop.
The fan will continue to operate for an additional three minutes in order to cool the dryer
after the warm air stops.
4. Press the Air Flow button (6) to adjust the air flow of the fan.
5. Press the Heater button (4) to stop warm air operation. The fan will operate for an additional three
minutes after warm air stops.
6. Turn off the main power switch to terminate operation.
NOTE The fan will continue to operate for an additional three minutes even when the
Power button (2) has been pressed without first switching off the heater (using the Heater
button (4)).
ENWW Basic operating procedure 15
How
to use the
dryer