Configuring, Configuring vmm on a microsoft cluster server – HP Insight Control Software for Linux User Manual
Page 13
NOTE:
You can hold the SHIFT key to select multiple systems.
NOTE:
A system presently or previously licensed with a demo key may not be relicensed
with another demo key.
If a selected product has not been registered with License Manager, the following message
is displayed:
License Manager cannot process licenses for the selected product for one of two possible
reasons:
For products where licensing information is managed by Systems Insight Manager, the Apply
Licenses page appears. Select one or more systems from this list and click Apply License Now.
The page refreshes and shows the updated license status. Select additional systems to make
more assignments, or reselect License Manager to refresh the page.
For products that require the license to be delivered to the actual target, the License Assignment
Results table appears and reports the status of the assignment process for each target. There
might be a delay in sending license data to some targets. You can continue with other Systems
Insight Manager activities during the license assignment process.
Configuring
Configuring WMI Mapper proxy server settings for Microsoft Hyper-V server
Insight Control virtual machine management uses the WMI Mapper proxy bundled with HP SIM
to manage the Microsoft Hyper-V server virtualization layer. If the WMI Mapper proxy is installed
on the server where HP SIM 7.0 or later is installed, no additional configuration is required in
VMM.
If the WMI Mapper proxy is installed outside the CMS, add the following configuration entry in
the Insight Control virtual machine management configuration file located at <Insight Control
virtual machine management installation directory on CMS>/bin/hpvmm.conf
for HP Insight Control virtual machine management to manage Microsoft Hyper-V servers:
WMIProxyServer = <IP address of the server where WMI Mapper proxy is
installed>
By default, the WMI Mapper proxy port used by Insight Control virtual machine management is
5989
. If the WMI Mapper proxy service is run on a different port, add the following configuration
entry in the HP Insight Control virtual machine management configuration file located at<Insight
Control virtual machine management installation directory on
CMS>/bin/hpvmm.conf:
.
WMIProxyPort =<Proxy port number>
After any changes to the hpvmm.conf file, for the changes to take effect, you must restart the
Insight control virtual machine management service on the CMS.
You can set the WMI Mapper proxy for the CMS through the HP SIM user interface by selecting
Options
→Protocol Settings→WMI Mapper Proxy. You can also add the system name.
Configuring VMM on a Microsoft Cluster Server
Insight Control virtual machine management supports high availability on a Microsoft Cluster Server.
HP SIM and Insight Control virtual machine management must be installed on the cluster nodes.
For more information, see the white paper at
Configuring
13