HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 21)

2 Setup
This chapter provides the following information:
• Shipping carton contents
• Installation and safety considerations
• Install the 4Gb SAN Switch
• Set the IP address
• Configure the 4Gb SAN Switch
Shipping carton contents
The 4Gb SAN Switch kit shipping carton contains three items, identified in Figure 3
and Table 5 :
• Brocade 4Gb SAN Switch for HP c-Class BladeSystem installation instructions
• SFP dust covers (must be inserted in ports where Small Form-factor Pluggable
(SFP) optical transceivers are not installed)
• One Brocade 4Gb SAN Switch with two or four SFPs installed. Models include:
• Brocade 4/12 SAN Switch for HP c-Class BladeSystem with twelve active
ports (ships with two Short Wavelengh (SWL) 4Gb SFPs installed, as shown
in Figure 3 )
• Brocade 4/24 SAN Switch for HP c-Class BladeSystem with sixteen internal
and eight external active ports (ships with four 4Gb SFPs installed)
• Brocade 4/24 SAN Switch Power Pack for HP c-Class BladeSystem with
sixteen internal and eight external active ports (ships with four 4Gb SFPs
installed)
Brocade 4Gb SAN Switch for HP c-Class BladeSystem 21