HP Brocade 4Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 26)

25319a
Figure 5 Installing the Brocade 4Gb SAN Switch into an interconnect
bay
4. Press the installation handle into the latch to lock the Brocade 4Gb SAN Switch
in place.
OA verifies power
As defined earlier, the HP BladeSystem Onboard Administrator (OA) is the enclosure
management processor that manages the devices contained within the enclosure. The
OA provides a single point from which to perform basic management tasks on switches
or server blades installed in the enclosure.
IMPORTANT:
HP recommends reading the appropriate HP BladeSystem Enclosure User Guide and the HP
BladeSystem Onboard Administrator User Guide . Reading these guides in sequence will
promote an overall understanding of your specific enclosure model.
Once the switch is installed in the interconnect bay, the OA verifies that the switch
type matches the mezzanine cards present on the servers. If there is no mismatch, the
OA powers up the switch.
If the switch does not power up, check the enclosure and switch status via the OA web
interface. Refer to the HP BladeSystem Onboard Administrator User Guide.
26 Setup