HP Identity Driven Manager Software Series - Manual (Page 154)

4-14
Using the Secure Access Wizard
Using Secure Access Wizard
DHCP address and mask - The base address and mask for the temporary
pool used by DHCP (base DHCP address default is 192.168.0.0, and
the mask default is 24 - 255.255.255.0).
Redirect URL
- The URL that the user should be redirected to after
successful login. The default is no redirect (blank field).
DHCP lease
- The lease length (days) of the IP address issued by DHCP
(default 10). Valid values are 5-25.
Client limit - The maximum number of clients to allow on one port
simultaneously, default is 1
Re-auth period - The re-authentication timeout (in seconds, default 0),
set to 0 to disable re-authentication. Valid values are 0-999999999.
Logoff period - The period of time (seconds) after which a client will
be considered removed from the port for a lack of activity. Disabled
by default, valid values are 0-999999999, 0 is disabled
Quiet period - The period of time the switch does not try to acquire a
supplicant. Valid values are 0-65535, the default value is 60 sec.
Max retries - Set number of times a client can enter their credentials
before authentication is considered to have failed (default 3). Valid
values are 1 - 10.
Server timeout
- The authentication server response timeout (default
30 sec). Valid values are 1-300.
Max requests - The maximum number of times the switch retransmits
authentication requests. Valid values are 1-10, the default value is 2.
Unauth-vid - The VLAN to which the port is assigned when the user has
not been authorized by web authentication. Valid values are any
defined VLAN, the default value is VLAN 1.
Auth-vid
- The VLAN to which the port is assigned when the user has
been authorized by web authentication. Valid values are any defined
VLAN, the default value is VLAN 1.
SSL login - Set whether to allow SSL login (https on port 443). This is
disabled (No) by default.
Allow client moves
- Set whether to allow client moves between ports.
The default is disabled (No).
If a device does not support the selected setting, the value you set will
appear in the SAW display, but will not be configured on that device.
d. Click OK to save the advanced settings and close the window.