Communications problems – HP OmniBook 800 Notebook PC User Manual

Page 60

Advertising
background image

60

To turn on DriveSpace for only removable drives: Exit Windows, run dscopy,
then press CTRL+ALT+DEL.

To turn off DriveSpace: Exit Windows, run dsdel, then press CTRL+ALT+DEL.

Communications Problems

If you have problems with serial communications

•

If you cannot make a serial connection at high speed (115K baud), try changing
the Power Management setting in the

System Configuration Utility

to “Moderate”

(from “Maximum”).

If you have problems with infrared communications

•

Move the devices to within about 1/2 meter (1.5 feet).

•

Check that only one application is using the infrared port.

•

Check that both devices are using the same protocol, such as IrDA.

•

Make sure you’re using the COM4 port. (For printing, use the LPT3 port instead.)

•

Start Infrared Monitor before you connect. In Control Panel, double-click
Infrared.

•

For an MS-DOS program using an infrared connection, run the program in an
MS-DOS Prompt window instead of in MS-DOS mode.

•

Try restarting Windows.

If an application can’t access a serial port

•

Check that the COM name you’re using is actually assigned to the port you’re
using.

•

If an application doesn’t support the COM port number assigned, change the port
number in the

System Configuration Utility.

•

Check whether another application is preventing access to the port, even if it’s
not actively using it.

•

Check in the communications application that you haven’t changed the address
and interrupt for the OmniBook port.

If the OmniBook stops responding after accessing a serial port

•

If the OmniBook stops working, try pressing the On/Off key to suspend and turn
on the OmniBook.

•

Reboot

the OmniBook.

If an I/O card stops communicating properly

•

It may have been reset if the OmniBook suspended or turned off. Exit and
restart the application, and plug in the ac adapter, if possible.

If a parallel device doesn’t work correctly

Advertising