HP ProLiant DL365 G5 Server - Manual (Page 39)

Hardware options installation 39
5. Install the DIMM.
6. Install the access panel (on page 20 ).
Hot-plug SAS and SATA hard drive options
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one hard drive is used, install it in the bay with the lowest device number (" SAS and SATA
device numbers " on page 14 ).
• Hard drives must be SFF types.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Removing hard drive blanks
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.