HP Media Center m270 Desktop PC - Manual (Page 23)

15
Existing setup Add the PC with a splitter
Wall
Cable
Coaxial
cable
Set-top box/
satellite Out
VCR In
VCR Out
TV In
Splitter In
Splitter Out
Remote
sensor
Remote sensor
control cable
TV (in) on
back of PC
Coaxial
cable
Coaxial
cable
Set-top box/
satellite In
Wall
Cable
Set-top box/
satellite Out
VCR In
VCR Out
TV In
Set-top box/
satellite In
Coaxial cable
Wall to Cable TV Set-top Box or
Satellite Box to VCR to TV Using
Coaxial Cable
Remove the coaxial cable at the input to the VCR, and
connect it to the input of a coaxial cable signal splitter
(not included; available at electronics stores). Connect
two coaxial cables to the splitter outputs. Connect one of
these cables to the input of the VCR and the other one to
the TV connector on the back of the PC.
Be sure to connect the remote sensor control cable
and position it on your set-top box or satellite box.
This allows the PC to change the channel on the box.
See “Connecting the Remote Sensor.”
Connections